new -Fuel Pump Power
Distribution Kit
new -
Clutch Damper
Delete & Hose Kit
new -
Clutch Slave
Hose Kit
new -ScienceofSpeed
NSX-R Engine Cover
new -AEM Series 2 EMS
for 1991-94 NSX
new -
Moton Club Sport
Shock Absorbers
new -
ScienceofSpeed FI
Exhaust Systems updated
- stealth license
plate bracket -for 2002+ NSX
new -
CT Engineering
Gen II Exhaust updated -
ScienceofSpeed
Billet Carbon
Twin Clutch
new -
3.5L NSX
Short Block
new -
AEM Series 2 EMS
for
1995-05 NSX
1.
Print a copy of the drawing and check dimensions both vertically and
horizontally to confirm it has printed to scale. Cut the drawing just
outside the dotted line.
2.
Gluing the drawing to a stiffer piece of material such as a manila
folder will make the template easier to use. Finish cutting directly
along the dotted line.
3.
Lay the template inside the wheel as shown.
4.
Verify that edge of the caliper does not touch the rim or the spoke. A
minimum of 2mm (0.080") is recommended.
![230-005[1].jpg (47329 bytes)](/products/exhaust_airflow_products/NSX/CT-Engineering/exhuast/230-005[1]_small.jpg)
1.
Print a copy of the drawing and check dimensions both vertically and
horizontally to confirm it has printed to scale. Cut the drawing just
outside the dotted line.
2.
Gluing the drawing to a stiffer piece of material such as a manila
folder will make the template easier to use. Finish cutting directly
along the dotted line.
3.
Lay the template inside the wheel as shown.
4.
Verify that edge of the caliper does not touch the rim or the spoke. A
minimum of 2mm (0.080") is recommended.