|
|
S2000 > ENPP > ScienceofSpeed Valve Springs, Retainers & Bases
 |
Hondata K-Pro |
| |
|
Hondata
K-Pro Engine Management System |
| |
 The Hondata
K-Pro Programmable ECU is a stand alone engine management system.
Replacing the factory ECU, the K-Pro allows full fuel, ignition, VTEC,
and driveability systems control. This is the ultimate stand alone
solution for high performance naturally aspirated and
supercharged/turbocharged 2000-2005 S2000s!
Unlike other engine management systems, the K-Pro is derived from a
factory Honda ECU. The K-Pro utilizes the factory sensors, allows
factory like start up, does not require modification to the factory wire
harness, and preserves the factory OBDII interface (compatible with
emissions station equipment and hand held scanners) and check engine
troubleshooting codes.
The Windows based software (KManager) is available freely to the end
user for parameter and table editing, calibration uploading, and
datalogging. |
|
|
|
Benefits of K-Pro: |
- OBDII scan tools work normally,
and is smog station compatible allowing smog stations to read an
OBDII all clear read out using the factory OBDII connector. The
K-Pro is not sold as a smog legal device - and is for offroad use
only.
- Factory gauges including water
temperature functions normally
- Replaces the factory ECU (no
external units to place in car)
- USB connection for speed and
compatibility
- Windows based KManager includes
datalogging to a laptop
- On board datalogging memory (2 mb
allows 10-110 min of data)
- Adjustment to different sized
injectors and overall fuel trim
- Configurable to any MAP sensor
- TPS based tuning allows
compatibility with ITBs
- Engine protection from over boost
and lean protection
- Expanded fuel and ignition tables
(both RPM and load) including both low and high (VTEC) camshaft
tuning
- Configurable VTEC control
- Launch control and anti-lag
- Three multipurpose outputs
(nitrous control, etc.)
- Supports lambda tracing from stock
wideband O2
- Pulse width modulation (PWM)
output allows boost control
|
|
Important notes: |
- K-Pro is currently available for
2000-2005 Honda S2000s only
- Factory immobilizer (like all
stand alone ECUs) is not supported
- K-Pro installation requires
replacing the following components (kit sold separately below as
part no enpp-1263):
- Crank sensor 37500-PZX-003
- Crank wheel 13622-PCX-013
- TDC sensor 37510-PZX-003
- TDC wheel 14112-PCX-003
- Valve cover 12310-PCX-020
- Drain plug washer (for PCV valve) 94109-14000
- PCV valve 17130-PCX-003
- IAT sensor 37880-P05-A00
- Installation bracket and wire
harness included
- Customers may supply the factory
RSX Type-S core ECU used for the K-Pro system (note, this is not the
ECU installed in your S2000). Supplying a useable core will result
in a decrease of the price by $400.00. Note that the factory list
price on the ECU is $708.00 so it is in general less expensive to
allow Hondata to supply the ECU. Customer supplied ECUs must:
- have a part number of 37820-PRB-A01 through A12 or 37820-PRB-305
- free of internal damage or defects
|
|
 |
|
|
specs |
|
fitment: |
S2000, 2000-05 |
|
|
|
|
|
|
|
|
|
