AEM CAN Bus Expansion Module

Description

The AEM CAN Bus Expansion Module is designed to work with other AEMNet compatible products like the AEM CD-5 and CD-7 race dashes to allow additional inputs to be added. These inputs include fuel level sensor, high beams, and any other inputs that you do not have enough inputs for with the ECU you are using.

The AEM 6 Channel CAN Sensor Module is typically used with a CD-5 or CD-7 dash when you wish to display a fuel level sensor, and perhaps a few sensors that you don't have room for in your ECU.

The AEM 22 Channel CAN Sensor Module is typically used with a CD-5 or CD-7 dash when you wish to display a fuel level sensor, but have many more inputs you wish to add that you don't have room for in your ECU.

Features

6 channel:

  • 1 x dedicated fuel level input (0 to 250 Ohm range)
  • 2 x temperature (thermistor) inputs
  • 2 x dedicated 0-5V analog inputs
  • 1 x tachometer/coil input
  • Fixed CAN bus speed, header length, and base address
  • IP67 Potted Enclosure / Sealed Connector - "dust tight" and protected against water spray
  • Protected inputs

22 channel:

  • 1 x dedicated Fuel Level input (0 to 250 ohm range)
  • 4 x dedicated 0-5V Analog inputs
  • 4 x Temperature (thermistor) inputs
  • 4 x user-configurable Analog inputs, (jumper selectable; 0-5v, thermistor, or RTD)
  • 6 x configurable Digital or Frequency inputs, active low, protected to ~18v, frequency, duty cycle or simple switch
  • 1 x Tach input, trigger when low, 12v internal Pull Up
  • 2 x VR Pair Frequency inputs (crank, wheel or drive shaft speeds)
  • IP65-rated enclosure is ‘dust tight’ and water resistant
  • Wiring harness included with 36-inch flying leads and pre-wired CAN cable
  • Jumper selectable CAN bus speeds, 250k,500k,1M
  • Jumper selectable terminating resistor
  • Jumper selectable header length, 11bit or 29 bit
  • Dimensions: 4.7” L x 4.3” W x 1.4” H (not including connector)
  • Weight: 6.4oz / 180g
AEM CAN Bus Expansion Module

30-22XX

$0.00

* Required Fields